Rear Wheel Arch Liner (Left) for BYD e2, OE 12877336-00

Left. This is the left rear wheel mud flap, fitted at the rear of the car on the left side. On a UK car that is the nearside, the kerb side when you are parked normally. Before ordering, stand behind the car and identify the arch you are replacing rather than working from a photograph, because the two sides mirror each other and look very similar in isolation. The right-hand flap is a separate listing and will not fit this position.

That is expected. EL-3102130 is an alternative reference for OE number 12877336-00, and both point at the same left rear flap. Reference markings on trim are usually moulded into the reverse face and are easy to misread once the piece is dirty, so clean it before you write the number down. If the digits you find do not match either number, send us a photograph of the marking and the part through the quote route on this page and we will identify it for you.

Timing depends on whether the flap is already with us. Delivery time is confirmed with your quote. If you are holding the car off the road for a repair, ask us to confirm the current position against OE number 12877336-00 before you book the labour and we will come back to you. The shipping cost is confirmed with your quote.

The packaging details are shown on this page. A box that long goes by an oversize service rather than through a standard parcel network, so allow for a signature at the door and for somewhere to lay a long carton down. If your delivery point is a flat with restricted access, tell us at checkout so the carrier can be briefed properly.

This flap is plastic. A moulded flap in plastic is straightforward to offer up to the arch. The trade-off is that the fixing tabs are the weak point and will crack if the panel is forced into place, so start the fasteners loosely and only tighten once everything lines up. Nothing further is stated about the grade of plastic or about any coating on it, and we are not going to fill that gap with a guess.

This flap is black, and the mounting position is on the exterior of the car, so the piece is visible behind the nearside rear wheel once fitted. It arrives in that black finish. Nothing is stated about primer or a paintable surface, so do not plan a colour-matched respray on the assumption that the part comes prepared for it. Hold the new flap against the old one first. If the two do not match in tone, speak to your bodyshop before it goes on.

One version is offered against this OE number and it is the Original/Genuine one, made by BYD and supplied in New condition. No Aftermarket line has been set up for the left rear flap, so the choice on this page is simply whether to order it or not. That reflects how this listing is built rather than any judgement about parts sold elsewhere. If another supplier quotes you a different reference for the same position, send it across and we will check it against our own record.