Rear Shock Absorber for BYD Sealion 05 EV, OE 15026557-00

Because it falls into a dangerous goods class for transport. The unit is charged with gas under pressure, and items of that kind are restricted on the lanes we ship on, so it is not sold through the normal checkout and it does not travel as an ordinary parcel. That is a transport rule rather than a stock position. Use the quote route on this page with your vehicle details and the OE number 15026557-00, and the options for getting one to you or to your workshop can be set out first.

This damper appears on the fitment table for a single model. Suspension parts are matched to a specific vehicle, so a similar car from the same maker is not evidence that this one will suit it. Check the fitment table on this page against your own vehicle before going any further. If your car is not shown and you think it should be, check the OE number on the old part, or send a photograph of it and its label through the quote route on this page, and we will confirm against the OE number rather than assuming the fitment table has simply been left short.

The alternative reference held here is UNEA-2915800, and it identifies the same rear damper as 15026557-00. Either marking is a match. The unit sits under the car, so clean the old one before you decide what it says. If you cannot get a reading, or the reading matches neither reference, put the vehicle details and a photograph through the quote route on this page. Since this item cannot be ordered through the normal checkout in any case, that route is where the identification gets done.

Yes. This is a safety critical part, and a rear damper is part of how the car stays settled on the road, so the work belongs with a qualified fitter who can raise and support the vehicle properly. It is not a driveway job. There is also the transport class to account for, which is why the item goes through the quote route on this page rather than a basket. Have the workshop confirm what it needs, then send the vehicle details and 15026557-00 through that route.

Metal is the material used. It is supplied as a complete assembly, so it goes on as one piece and is not taken apart. Do not attempt to release or vent it, and do not put the old one in with ordinary household rubbish when it comes off, because of the restricted transport class it belongs to. The workshop doing the fitting will normally take the old unit away.

It mounts under the car at the rear, so it is out of sight until the vehicle is lifted. The car has to be raised and supported before the old one can come off, which makes it workshop work rather than a roadside change. You also will not be able to hold the new part against the old one on the drive in the way you could with a body panel. Use the fitment table and the quote route on this page to confirm it first.

This damper is available as an Original/Genuine part from BYD only, with no Aftermarket alternative, so there is one version rather than a choice. On a part that is both safety critical and restricted for transport, nothing is added to a second tier until it has been checked against the same vehicles. If you want an alternative considered, raise it through the quote route on this page with the vehicle details and 15026557-00, and it can be compared before any commitment is made on your side.