Front Bumper Lower Trim (Right) for BYD Yuan PLUS, OE 16068185-00

The right. This listing carries a right lateral position, with front and lower positions alongside it, which puts it along the bottom edge of the front bumper on the right hand side. Work the side out from the driving seat looking forward rather than from standing in front of the car, because that is where the confusion starts. The side forms part of what this OE number identifies, so settle it before you order. Hold the old trim up to the car, or read the number on the back of it and compare with OE 16068185-00.

The Original/Genuine version is the piece as supplied by BYD. The Aftermarket version is a different source for the same item under the same OE number, 16068185-00, and both tiers are priced on this page. Neither is second hand. The condition on this line is new either way. Fitment does not change between them, so the fitment table on this page applies to both. Workshops doing a straightforward repair often take the aftermarket route, while owners keeping a car close to how it left the marque tend to stay with the genuine one.

Not necessarily. This line runs under an alternative reference as well as the OE one. The OE number is 16068185-00 and the alternative is SC2EV-2803152. Which of the two ends up on the part depends on who moulded it, so a different string is common and is not by itself a sign of trouble. Clean the back of the old trim and read the number in good light before matching it against either reference. Where it lines up with neither, put the number through the quote route on this page rather than ordering blind.

Delivery takes 8 to 28 days from your order to your door. Anyone needing a firmer date than that should use the quote route on this page and give OE 16068185-00 with the request. The shipping cost for your country is shown on this page and confirmed at checkout before you pay. Before you order, check the OE number on your old part against the one on this page.

Plastic. It is a moulded trim piece rather than a structural one. Being a moulding, it will give a little as you offer it up to the car. It also means a firm knock will crack it instead of denting it, so keep it in its packing and out of the way of the rest of the work until the moment it goes on. The fitment table on this page shows what it belongs to.

Black, and since the mounting is on the outside of the car it will be visible when the job is finished. Lower bumper trims are often left black from the mould, in which case it goes straight on as supplied. If the equivalent piece coming off your own car is painted in the body shade, then this one needs the same treatment before fitting and that is paint shop work. Use the old trim as your reference.