Powertrain Rear Mount Support for BYD Yuan UP 2025-2026, OE 15722452-00

The title names one model, but the fitment table on this page is the part that decides it. This support appears against a broad set of vehicles, and small build changes inside a single model year can still matter underneath. Work down the table until you find your own vehicle line, then confirm OE 15722452-00 against the number on the support already fitted. Where the table and the old part disagree, trust neither and ask. Send a photograph of the old part and its label through the enquiry route and we will confirm which listing your car takes.

Two tiers are listed here. The Original/Genuine one is the BYD part, carrying OE 15722452-00. The Aftermarket one is built by another manufacturer to fit the same position, and it is priced separately on this page. This listing does not record an aftermarket brand name, so if that matters to you, ask before ordering and we will tell you what is coming. Both arrive new.

The alternative reference for this one is TA30-1001300C, alongside OE 15722452-00. Either string identifies this support, so do not walk away from the listing because the stamp does not match the title. Read the full number off the old part with the car raised and good light on it. Take the number from the part itself rather than from a paper invoice, since an invoice line may carry a supplier code instead. If the number you have matches neither of ours, send it over through the enquiry route and we will place it.

The delivery time is 8 to 25 days, from order to door. The support travels on the ordinary lane with no special handling attached. The shipping cost for your country is shown at checkout before you pay. Before you order, check the number on your old part against OE 15722452-00. If anything about the timing matters for a booked repair, ask through the quote route on this page.

It is metal. The listing carries no metal grade and no torque figure, so nothing of that sort should be read into the word metal. Have the fixings you need ready before the old support comes off, and work to the procedure your garage uses on this vehicle.

Underneath the car, towards the rear. Getting to it means raising the vehicle on a ramp or on stands rather than reaching in from above. Because the area is exposed to road spray, expect the fixings to be tight and allow time for them. Have a look at the old support in place before you order so you can see the shape and the fixing points, and compare that against the images on this page. If your car looks different underneath, use the fitment table before committing to the order.