Rear Brake Line (Left) for BYD Seal 05 & Qin PLUS, OE 14890907-00

This is the left hand item, catalogued as the left rear brake hard line, so it will not follow the routing used on the other side of the car. Sides are read from the driver's seat looking forward, not from standing behind the car. Before you touch a union, lay the old line on the bench beside the new one. The bend pattern is the quickest way to confirm you have the correct hand. If your car is not shown in the fitment table on this page, use the quote route and give us the OE number 14890907-00.

Not necessarily. This line is also catalogued as HA5HA-3506070, and that is the reference you are most likely to find on a part fitted to a car built for the home market. Both numbers land on the same item. Clean the old line and read the marking carefully, then check it against 14890907-00 and against the alternative above. If it matches neither, send us whatever characters you can make out along with the vehicle details, and we will work it back through the fitment table on this page.

Yes. This is a safety critical item and it sits in the braking system, on the underbody at the rear of the car. Work of that sort means opening a pressurised hydraulic circuit, and the car should not go back on the road until someone competent has checked it properly. If that is beyond what you are set up for, buy the part here and book the labour with a garage you trust. Take the OE number 14890907-00 along so the fitter knows which line is arriving.

Delivery time is confirmed with your quote. If the car is off the road and the timing is tight, tell us before you commit and we will confirm the position against the OE number 14890907-00 and your vehicle details. The shipping cost is confirmed with your quote. Before you order, check the number on your old part against OE 14890907-00.

This travels as a long parcel rather than a small boxed item. The lane is decided by its length rather than its weight. Check that your delivery address can take a package of that length and that somebody will be there to receive it. A kerbside handover at a flat with no lift is where these go wrong. If a workshop address is easier, give us that one instead. The packaging details are shown on this page.

Metal, so this is a hard line section with its bends already formed to suit the underbody routing rather than a flexible hose. Feed it along the floor by the ends and keep it from kinking as it goes in, because a metal line pulled out of shape will not sit properly along its intended run. Compare the bend pattern with the part you removed before you commit to fitting it. If the shape differs, stop there and check your own variant against the fitment table on this page.

Only the Original/Genuine version is listed, built by BYD. We have not sourced an Aftermarket equivalent for this line, so there is no second tier to weigh up and the price shown on this page is for the genuine item. On a hydraulic part with formed bends that tends to be the sensible way round in any case. If you would like us to look for an alternative, use the quote route with the OE number 14890907-00 and your vehicle details, and we will tell you plainly what can be had.