Rear Shock Bump Stop for BYD Seal 05 & Qin PLUS DM-i, OE 12696320-00

This bump stop fits a spread of BYD models and a wide set of individual vehicles, so the Seal 05 and the Qin PLUS DM-i in the title are headline applications rather than the full picture. Check your own model year and variant against the fitment table on this page. If your car is not shown there, or you are not certain which of the variants yours is, send the OE number from the old part through the quote route and we will confirm the match before quoting.

Both are. Suspension rubbers are often marked faintly, so clean the part before you try to read it. Where neither reference matches what you can make out, send the characters you can read through the quote route along with the vehicle details, and we will identify it from our data rather than have you take a chance. Keep the old rear shock absorber bump stop until the new one is fitted, in case the two need comparing.

Yes. This item is safety critical, and it sits underbody within the rear suspension, which means the car has to be supported properly and the surrounding fixings dealt with correctly. Use a qualified technician with the right equipment. We publish no torque figures and no fitting sequence for it, and none of it should be assumed from the listing. When you enquire through the quote route, tell us who is doing the work so the item can be sent where it is needed.

Allow 8 to 25 days for delivery, counted from your order to your door. Once it arrives, check it against the old bump stop you are replacing, just to be sure it is the right shape before it goes anywhere near the car. If anything about the timing looks off once your order is placed, use the quote route on this page to ask.

Rubber is the material used for this bump stop, with no further detail on compound or hardness available. Treat it as the material family rather than a full specification. Being rubber, it is flexible rather than rigid, so it needs no more than normal careful handling once unpacked. We cannot give a life expectancy or a replacement point for it, since that is not specified. If you need a written material specification for a workshop file, ask for it through the quote route on this page.

This one sits underbody, at the rear of the car, within our shock absorbers and struts category. That is the extent of what we state about where it sits, and no access detail or fitting sequence is published. Check the fitment table on this page against your own car, then compare the packaging details on this page with the item you are replacing. Send anything that does not match through the quote route before you take the enquiry further.

There is one version of this bump stop, the Original/Genuine part from BYD, and no Aftermarket alternative is offered for 12696320-00. So this item carries a single tier. Given that this item has to go through the quote route in any case, tell us in the same enquiry if you would rather we looked for an independent equivalent, and we will say whether one can be sourced for this reference. Otherwise the BYD version is the one we are able to offer you.