Fuel Filler Hose for BYD Seal 05, OE 12936411-00

This filler hose fits more than one model, so the fitment table on this page is the thing to trust rather than the model name in the title. Work down it and match your own car's exact variant and build year. If you want to be certain, take the OE number off the hose you are removing and compare it with 12936411-00 as shown here. Where the old part is unreadable, send a photograph of the old hose and its label through the quote route and we will check the fitment against the OE number for you.

Old stock and workshop labels do not always carry the same reference. This hose is catalogued under OE number 12936411-00 and is also known as HA2HE-1104210, so either marking points at the same part. Clean the moulding on the hose you have taken off and read it under good light, since rubber picks up road dirt and the digits fade. If what you find is neither of those two references, do not order on a guess. Send the number you can read through the quote route and we will confirm it against the OE number first.

The delivery time is 8 to 25 days, from order to door. If the vehicle is off the road and the timing is tight, tell us when you place the order and we will tell you what the current position on this OE number looks like. The shipping cost for your country is shown on this page and confirmed at checkout before you pay. Before you order, check the number on your old part against OE 12936411-00.

This line is made of rubber. That has practical consequences at fitting time. A rubber hose will take a bend that a rigid line will not, but it should not be forced over a stub with sharp tooling, and the clamps that held the old one should be checked for distortion before they go back on. Store it flat until the day of the job. Beyond the material itself nothing is said about service life, so treat anything you read elsewhere on that subject with caution.

This one mounts underbody, which is where the filler neck runs down toward the tank. Plan the job around access more than around the part itself. You will want the car properly raised and supported, and it is worth looking at the condition of the surrounding clamps and shields while you are under there, because they are easier to deal with in the same session. Nothing here describes the fixing method, so check what is actually holding the old hose in place before you order any additional hardware.

This hose comes in one version. The Original/Genuine line from BYD is the one shown, and no Aftermarket equivalent is offered against OE number 12936411-00, which is why a single tier appears on this page instead of two. If an alternative appears later it will show here as a second tier. Until then, the number to quote when you order or ask a question is the OE number itself.