Rear Left Door Weatherstrip for BYD Seal 05 & Qin PLUS, OE 12225862-00

The left one, and the rear door rather than the front. Sitting in the car and facing the windscreen, the left side is on your left hand. Both handing and front to rear position matter here, so a strip from the front door on the same side will not do the job and neither will the right hand rear. Check the door you have taken apart before ordering. Where a car has been in a rear quarter shunt and both doors are off, order each side under its own reference rather than doubling up on this one.

This part answers to two references. The OE number is 12225862-00 and it is also held as HAD-6207111, so a strip stamped with either one leads back here. Old seals often carry the second style of reference on a moulded tag rather than the OE number, and the print can be faint once the rubber has been on a car for a few years. Clean the tag and read it in good light. If what you find matches neither, pass the number and your vehicle details through the quote route.

Delivery time is confirmed with your quote. It is worth ordering before the door is stripped rather than after, so the car is not standing open to the weather while you wait. The shipping cost is confirmed with your quote. Before you order, check the number on your old part against OE 12225862-00.

The packaging details are shown on this page. It travels by courier, so give a delivery address where somebody can take it in during the working day. Leave enough room to lay it out flat once it arrives, rather than trying to unroll it in a tight space. Do not fold it to get it indoors. Once it is flat, treat it gently until it goes on the car.

Rubber, and that is the material for this rear door part. For a section this long, that means it wants laying out straight and left alone for a while before it goes anywhere near the car. Cold rubber is stiff and it fights you at the corners. Warm it up in the room first, then work the strip round the aperture steadily instead of stretching it from one end to the other. The material is what this page covers here. How it is fixed to your particular door is not covered.

It arrives black and it is meant to stay that way. Black is the colour for this rear door strip, so there is no preparation to do before it goes on the car. Paint or dye on a sealing surface will not hold and it spoils the way the strip beds down when the door shuts. If you are matching it against a strip on the opposite side that has faded in the sun, expect the new one to look deeper for a while. Wipe it clean and fit it.

Only the Original/Genuine part exists for this reference, and it comes from BYD. No Aftermarket alternative is carried against OE number 12225862-00, which is why the page shows a single version instead of two tiers side by side. This single version is the whole picture for this rear door seal. Should you want alternatives looked into, the quote route takes the reference from the old strip, and anything that would serve the same position can then be checked for you.