Exhaust Rubber Hanger for BYD Tang L DM, OE 12157932-00

This hanger fits a wide range of BYD models and a much wider set of individual build variants, which is common for a small rubber mounting but also a trap. A part shared across many builds is not shared across all of them. Open the fitment table on this page and find your exact model, build year and variant rather than stopping at the model name. If your car appears under a name that differs slightly from the one you know it by, send a photograph of the old part and its label through the quote route and we will confirm it before you order.

If the hanger you are pulling off carries HADF-1200011 rather than the OE number 12157932-00, you have the right part. Both references describe this hanger. In practice a rubber hanger that has been on the car a while will have no readable number left on it at all, and there is nothing unusual about that. When the marking has gone, work from the car instead. Send a photograph of the old hanger in place, together with its label, through the quote route, and we will match it against the OE number rather than from a worn moulding.

The delivery time is 8 to 25 days, from order to door. The packaging details are shown on this page. Small parts are the ones people order last and then wait on, so if the car is going up on a ramp for other underbody work, order the hanger at the same time as everything else rather than once the exhaust is already down.

This hanger is rubber and the colour is red. Rubber means the part arrives soft enough to check by hand for splits and tears before it goes anywhere near the car, and it is worth doing that while the box is still open on the bench. Beyond material and colour there is no hardness rating and no compound detail given for this part. If your workshop needs that level of specification before it will fit the part, ask through the quote route and we will go back to BYD for you.

This hanger is fitted at the underbody, so it is reached from beneath the car and not from the engine bay. That decides how the job is done, since it means planning for the car to be raised and for the exhaust to be supported while the old hanger comes off. Only the underbody position is given, so it does not say how far back along the system this particular hanger sits. Work from the BYD layout for your model, and check your model against the fitment table on this page.

The hanger is offered in the Original/Genuine tier only. No Aftermarket line exists for OE number 12157932-00, so there is one option on this page rather than two. The part is new and carries the BYD reference. Where both tiers exist for a part we show them together on the same page, so nothing is being held back elsewhere on the site. If you are replacing more than one hanger on the same system, or want the neighbouring mountings quoted at the same time, use the quote route and include a photograph of the old part and its label.