Front Bumper Reinforcement Beam for BYD Seal 05 DM-i, OE 12584418-00

Two tiers are listed. The Original/Genuine beam is the one made to the vehicle manufacturer's own specification, with BYD as the manufacturer. The Aftermarket beam comes from another producer and is made to fit the same application, and it is priced separately on this page. Both are supplied new. Which one suits you tends to follow what the car is for and how long you intend to keep it. Whichever tier you pick, check the fitment table on this page against your own vehicle first, since the fitment question is identical for both.

It may well be. This item also carries the reference HAD-8400010/70, so that reference belongs to the same part. Front beams take knocks and get sprayed over, so the marking is often hard to read once the bumper cover is off the car. Look along the face and at both ends before deciding. If neither reference turns up, note what you can read and send it with the vehicle details through the quote route on this page, and it will be confirmed for you.

Delivery time is confirmed with your quote. The point matters more here than on a small part, because a car with the front stripped is usually sitting in a workshop while it waits. Confirm the position on OE 12584418-00 through the quote route on this page before you book the bay if the timing is at all tight.

It is a long item and it travels whole, as a long parcel. The packaging details are shown on this page. This goes out as an oversized consignment and not in a standard parcel. Make sure the delivery address can take a long package and that somebody will be there to receive it, because it is awkward to manoeuvre through a narrow doorway. A workshop address is often the easier option for a part this shape.

It is made from metal, which governs how the part behaves in transit and in the hand. It arrives rigid, so nothing needs straightening before it goes on, and its ends will mark paintwork or a garage floor if it is set down carelessly. Unpack it flat and keep it supported near both ends, and have a second pair of hands ready before you start offering it up to the car.

It sits at the front of the car. The mounting position is exterior and the longitudinal position is front, so it belongs to the outer structure and not to anything inside the cabin. No side is given for it, which fits a single beam running across the front instead of a handed left and right pair. Before ordering, check the fitment table on this page against your own car, and compare what you can see on the vehicle with the packaging dimensions given on this page.